Ethernet configuration

To configure Ethernet connection parameters, go to Configuration → Ethernet.

The user can choose whether to use DHCP or not for IP address assignment.
DHCP is enabled by default.

If DHCP is disabled, it is necessary to enter IP address, Netmask, Gateway and DNS manually.

After pressing Save button, a confirmation pop-up will appear.

After confirmation, in order to apply the new Ethernet configuration, the gateway must be rebooted by pressing button on top right.

Note: if the DHCP is disabled and the IP address is assigned manually, after reboot, the web interface will be available at the new configured address.

Since firmware version v1.4.0.221, on the TinyGateway PoE is also possible to configure the WiFi network interface. The WiFi network interface could be enabled in parallel to the Ethernet interface if set up in Access-Point mode, otherwise, if set up in Station mode, the WiFi interface and the Ethernet interface are exclusive.